HomeMy WebLinkAboutR-2 Zoning Compliance Summary ChecklistBuilding Permit Number : ________________
PROPERTY INFORMATION
Address : ________________________________________ Y / N
Lot Depth : ____________Min. Basement El : ________ Y / N
Lot Width : ____________Prop. Basement El :________ Y / N
Lot Area : ____________ Y / N
Lot # : ____________ Y / N
Y / N
SETBACKS Stat. Right-of-Way : Y / N
Minimum Proposed Complies*
3.0 metres m
13.0 metres m
1.2 metres m
Right Side 1.2 metres m
Flanking Street 3.0 metres m
3.0 metres m
5.5 metres m
8.0 metres m
1.2 metres m
Right Side 1.2 metres m
Flanking Street 3.0 metres m
2.0 metres m
11.0 metres m
1.0 metres m
0.45 metres m
Other side Prop. Line 2.0 metres m
4.5 metres m
m
m
m
m
Y / N
Dwelling's Corner Grade Elevations
(metric)Left Right
Front finished gr.a) c) (lowest of existing or finished grade on Left side ))/ 2 = m
Rear finished gr.b) d) REAR DDP Avg CALCULATION (RDDP Avg) please see reverse
Front Existing gr.e) g)
Rear Existing gr.f) h) (lowest of existing or finished grade on Left side ))/ 2 = m
Avg finished grades around dwelling = (a) + b) + c) + d)) / 4 = __________m
Basement Floor Elevation= _________ - Avg of Finished grades around the dwelling ___________ = ___________m
storey basement
FRONT SLOPE CALCULATION (for negative gradient lots only as measured from Avg Curb Elevation to the Front Datum Determination Avg.)
Avg curb elevation (k) =m Horizontal length from Avg. Curb EL to the FDDP Avg (L) = m
Front DDP Avg (i) =m Slope Calculation = ((k - i) / L) x 100 = __________ %
Qualifying for a height bonus (for dwelling only)? Y / N 10% or greater = 0.5m (1'-7.5") 15% or greater = 1.0m (3'-3.5")
BUILDING HEIGHT Roof pitch Maximum height permitted Bonus Proposed Complies
Principal Building m m
Detached Parking/Accessory structure m m
HIGHEST BUILDING FACE Maximum Proposed Complies
complies with sloping 7 m Highest Building Face line (from existing grades)7.0m m
complies with sloping 7 m Highest Building Face line (from finished grades)7.0m m
40% exemption rule applied? Y / N 40% %
RETAINING WALLS walls over 1.0 metre in height require P.Eng design Proposed Complies
m
BUILDING COVERAGE Maximum %Proposed %
50%%m2
12%%m2
Planchecker __________________________________ date: __________
City of Maple Ridge
11995 Haney Place, Maple Ridge, BC V2X 6A9 Tel: 604-467-7311 Fax: 604-467-7461
Inquires at: permits@mapleridge.ca Web site: www.mapleridge.ca
Front
Rear
Plan: ____________________
Left Side
Principal Structure for lots with
a rear lane
Water Management :
COVENANTS REGISTERED ON TITLE:
Comprehensive Design :
Geotechnical :
Fish & Wildlife :
DP30 Area :
Flood Plain :
Min. setback to projections (bay windows, hutches, nooks, etc) from abutting interior side lot line 0.90m (3' - 0")
Lane/Rear Prop. Line
Front Prop. Line
Interior Side Prop. Line
Separation between principal residence use
BP file #
Max. 0.3m overhang into rear
or int. side yard
Detached Garage / Carport /
Accessory structures
Flanking Street Side
Principal Structure for lots
without a rear lane Front of attached garage
Rear
Left Side
Front
Maximum Roof projection into interior side yard 0.61m (2' - 0")
Vehicular access for lots backing on a Municipal lane will be restricted to the lane
maximum of 2 storeys is permitted for this dwelling. Is this proposal a 2 storey dwelling?
Maximum Roof projection into front, rear or exterior side yard setbacks 1.25m (4' - 1")
Maximum Roof projection into interior side yard for detached accessory buildings 0.30m (11.75')
FRONT DDP Avg CALCULATION (FDDP Avg) please see reverse
Revised Dec 2015
((Lowest of existing or finished grade on Right side) +
m2Accessory Structures
All Buildings & Structures m2
((Lowest of existing or finished grade on Right side) +
Y / N
if more than 300mm (below the Avgd finished grades), then the lower level is a basement.
Maximum area (in metric)Proposed area (in metric)
11.0 metres
4.9 metres
RETAINING WALLS: maximum 1.20 m (4' - 0") height
R - 2
Secondary Suites
are not permitted in
this zone
**Please be advised that this handout is a Zoning Bylaw summary only.
Please refer to the Zoning bylaw for complete information.**
Zoning Compliance Summary Checklist
Buildings & Structures for one Family Residential Use
BUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINE - means:
I. averaging the two front Datum Determination Points on the lot; and
II. averaging the two rear Datum Determination Points on the lot; and
III. longitudinally extending a line joining (i) and (ii); illustrated by way
of the following diagram;
DATUM DETERMINATION POINTSDATUM DETERMINATION POINTSDATUM DETERMINATION POINTSDATUM DETERMINATION POINTS - means the two
points on a lot created where the front most and
rearmost wall face of the principal building, or
projections thereof, intersect with the outermost
sidewall faces, or projections thereof, measured
as the lesser of Natural or Finished Grade.
LOCALIZED DEPRESSIONLOCALIZED DEPRESSIONLOCALIZED DEPRESSIONLOCALIZED DEPRESSION - means:
I. an existing depression in Natural Grade not exceeding 3 metres (9.8ft.) in width, or the lesser of 3 metres or 20% of the wall length along any building wall that
it intersects;
II. a depression below Finished Grade created for the purposes of providing vehicles or pedestrian entrance to a building subject to the following conditions:
A. only one vehicle entrance and one pedestrian entrance are permitted as Localized Depressions on a single family residential building.
B. on any side of the building in a single family residential zone, the Localized Depression width shall not exceed the lesser of 50% of the corresponding
building width or:
* 6.0m (20 ft.) width for vehicle access.
* 2.44m (8 ft.) wide 3.0 m2 in area for a pedestrian access.
* 7.3m (24 ft.) wide for a combined vehicle and pedestrian access
III. any combination of vehicle or pedestrian entrances and existing depressions remaining after finish grading shall not exceed 50% of the corresponding building
width or length along any side of a building.
Highest Building Face Exemptions:Highest Building Face Exemptions:Highest Building Face Exemptions:Highest Building Face Exemptions:
I. 40% of the length of the building face can be exempt from this regulation. Different parts of the building face can be exempted, provided that the
sum of their lengths does not exceed 40% of the total length of the elevation.
II. 100% of the length of the rear building face for those lots whose entire rear lot line abuts land dedicated for park purposes by subdivision plan, within
which a watercourse shown on Schedule āEā exists, provided that the Highest Building Face is identified on the rear building elevation.
III. 100% of the length of the interior side building face for those lots whose entire interior side lot line abuts land dedicated for park purposes by
subdivision plan, within which a watercourse shown on Schedule āEā exists, provided that the Highest Building Face is identified on the interior side
building elevation.
IV. Roof eaves, decks, decorative features, and the pitched roof portion of either gable ends or dormers are exempt.
V. Any portion of the roof structure above the top plate is exempt from this calculation.