HomeMy WebLinkAboutRS-1 Agricultural Zoning Compliance Summary ChecklistBuilding Permit Number : ________________
PROPERTY INFORMATION
Address : ________________________________________ Y / N
Lot Depth : ____________Min. Basement El : ________ Y / N
Lot Width : ____________Prop. Basement El :________ Y / N
Lot Area : ____________ Y / N
Lot # : ____________ Y / N
Y / N
SETBACKS Stat. Right-of-Way : Y / N
Minimum Proposed Complies*
Greenhouse 15 metres m
15 metres m
7.5 metres m
Right Side 7.5 metres m
7.5 metres m
15 metres m
* City of Maple Ridge use only
30 metres m
30 metres m
30 metres m
7.5 metres m
15 metres m
30 metres m
Dwelling's Corner Grade Elevations
(metric)Left Right
Front finished gr.a) c) (lowest of existing or finished grade on Left side ))/ 2 = m
Rear finished gr.b) d) REAR DDP Avg CALCULATION (RDDP Avg) please see reverse
Front Existing gr.e) g)
Rear Existing gr.f) h) (lowest of existing or finished grade on Left side ))/ 2 = m
BUILDING HEIGHT Roof pitch Maximum height permitted Bonus Proposed Complies
Building and structures m m
BUILDING COVERAGE Maximum %Proposed %
10%%m2
20%%m2
total coverage for ALL buildings and structures 40% %m2
Planchecker : __________________________ Date : ____________
City of Maple Ridge
11995 Haney Place, Maple Ridge, BC V2X 6A9 Tel: 604-467-7311 Fax: 604-467-7461Inquires at: permits@mapleridge.ca Web site: www.mapleridge.ca
Flanking Street Side
Agricultural Land Reserve :
Plan: ____________________
Fish & Wildlife :
Flood Plain :
Left Side
Front
Water Management :
DP30 Area :
Geotechnical :
Rear
Front Prop. Line
Flanking Street Side
Stamp area (for City use only)
Proposed area (in metric)
FRONT DDP Avg CALCULATION (FDDP Avg) please see reverse
((Lowest of existing or finished grade on Right side) +
((Lowest of existing or finished grade on Right side) +
Building and structures for
agricultural use
Greenhouse Structures m2
9.5 metres
Agricultural use - means a use of providing for the growing, rearing, producing and harvesting of agricultural products;
includes the preliminary grading of such products for shipment, and specifically includes mushroom growing, horses,
livestock, swine, fur bearing animals, poultry, pigeons, doves, bees, or other animals or birds; excludes all manufacturing and
any processing not specifically included.'
Revised Dec 2015
from a building used for one family residential use
m2
of swine or mink: and c) shall not be permitted on RS-1 unless these lands are designated as "Agricultural Land Reserve"
**Agricultural Use: Please be aware that a) lot area must be over 0.4 hectares; b) shall not include mushroom growing or the keeping
Lane/Rear Prop. Line
Buildings & Structures for agricultural use only m2
from a building used for one family residential use
wells and streams
BP file #
Interior Side Prop. Line
Maximum area (in metric)
RS - 1 (Agricultural)
**All Buildings and
structures proposed for
this zone may require
ALC approval
**Please be advised that this handout is a Zoning Bylaw summary only.
Please refer to the Zoning bylaw for complete information.**
COVENANTS REGISTERED ON TITLE:
Zoning Compliance Summary Checklist
Buildings & Structures for one Family Residential Use
BUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINEBUILDING HEIGHT BASE LINE - means:
I. averaging the two front Datum Determination Points on the lot; and
II. averaging the two rear Datum Determination Points on the lot; and
III. longitudinally extending a line joining (i) and (ii); illustrated by way
of the following diagram;
DATUM DETERMINATION POINTSDATUM DETERMINATION POINTSDATUM DETERMINATION POINTSDATUM DETERMINATION POINTS - means the two
points on a lot created where the front most and
rearmost wall face of the principal building, or
projections thereof, intersect with the outermost
sidewall faces, or projections thereof, measured
as the lesser of Natural or Finished Grade.
LOCALIZED DEPRESSIONLOCALIZED DEPRESSIONLOCALIZED DEPRESSIONLOCALIZED DEPRESSION - means:
I. an existing depression in Natural Grade not exceeding 3 metres (9.8ft.) in width, or the lesser of 3 metres or 20% of the wall length along any building wall that
it intersects;
II. a depression below Finished Grade created for the purposes of providing vehicles or pedestrian entrance to a building subject to the following conditions:
A. only one vehicle entrance and one pedestrian entrance are permitted as Localized Depressions on a single family residential building.
B. on any side of the building in a single family residential zone, the Localized Depression width shall not exceed the lesser of 50% of the corresponding
building width or:
* 6.0m (20 ft.) width for vehicle access.
* 2.44m (8 ft.) wide 3.0 m2 in area for a pedestrian access.
* 7.3m (24 ft.) wide for a combined vehicle and pedestrian access
III. any combination of vehicle or pedestrian entrances and existing depressions remaining after finish grading shall not exceed 50% of the corresponding building
width or length along any side of a building.
Highest Building Face Exemptions:Highest Building Face Exemptions:Highest Building Face Exemptions:Highest Building Face Exemptions:
I. 40% of the length of the building face can be exempt from this regulation. Different parts of the building face can be exempted, provided that the
sum of their lengths does not exceed 40% of the total length of the elevation.
II. 100% of the length of the rear building face for those lots whose entire rear lot line abuts land dedicated for park purposes by subdivision plan, within
which a watercourse shown on Schedule āEā exists, provided that the Highest Building Face is identified on the rear building elevation.
III. 100% of the length of the interior side building face for those lots whose entire interior side lot line abuts land dedicated for park purposes by
subdivision plan, within which a watercourse shown on Schedule āEā exists, provided that the Highest Building Face is identified on the interior side
building elevation.
IV. Roof eaves, decks, decorative features, and the pitched roof portion of either gable ends or dormers are exempt.
V. Any portion of the roof structure above the top plate is exempt from this calculation.